Broken Off Stones
Older tablet-style stones that are set into bases can break off near the stress point where the base supports the tablet. If the break is clean enough, the marker can be repaired in place using two-part epoxy and mortar.
The following steps demonstrate one approach to on-site repairs for resetting a broken grave marker:
- Clean up the broken edges to be bonded with epoxy, removing dirt, debris, or other contaminants that might interfere with a tight bond.
- Confirm that the base is solidly supported and will hold the tablet upright and level; if needed, reset the base by following the approach in the guide for sunken markers.
- Mix two-part epoxy and apply in a line along the center of the broken edge of the stone remaining in the base, leaving room around the periphery for the epoxy to expand as the stones come together.
- Lift the tablet into place manually or with a hoist, ideally lowering it straight down to allow epoxy to spread evenly.
- Support the tablet with piece of lumber and clamps, either vertically aligned with the stone or braced against the ground at an angle.
- Allow 24 to 48 hours for the epoxy to set, depending on weather conditions.
- Once the epoxy is set, use fine lime mortar to fill the joints and cracks, preventing water intrusion.
The slideshow below demonstrates different stages of the process.



