Sunken Stones
Lifting Sunken Markers
One basic resetting task involves lifting a marker sunken in the ground, leaving it at an angle. If the marker is small enough or only needs to be elevated slightly, pry tools may be sufficient for this task.
The following list is an example of the steps one might take to reset a lighter stone or vault cover sunken in the ground.
- Dig around the lift end, making sure to avoid hitting the stone with shovels, to expose the lowest edge that will be the lift point
- Place a pry bar under the lift point, protecting the stone with fire hose or canvas if that part will be visible once finished
- Place 2x4 lumber or other support under the pry bar to help spread the pressure
- Using leverage from the pry bar, ease the stone up in increments, placing lumber underneath the stone at each stage to maintain the lift while adjusting the pry bar position
- Elevate the stone slightly above the intended final position and support with lumber, ideally at multiple points
- Use shovels to spread gravel evenly beneath the stone
- If the hole is very deep, use reclaimed soil from a nearby area to backfill; some cemeteries have piles of dirt leftover from excavations that will match the surrounding soil
- Raise the stone to remove the supports and then lower it into final position. Check the level and re-raise to add or remove gravel as needed.


